SatLab SL600 - 6 Trouble Shooting

www.satlabgps.com
59
Unit does not start
Bluetooth Connecon fails
Base / Rover UHF fails
Baery
Power Buon
Firmware Failure
Firmware Failure
Pin Code
COM1 Cable
Radio Parameters
Channel Number
Make sure that there is at least one baery
placed and secured in the barey compartment
with some power.
In order to Power On or O the receiver, power
buon is needed to kept pressed for at least
three seconds. This is to avoid pressing power
buon by mistake.
Reset Receiver by F1 or sending $$RST by any
terminal tool.
Upgrade rmware or consult to Local Dealer
In order to connect to SL600 by Bluetooth, a
pin code of 1234 is required. Without pin code,
bonding Bluetooth is not possible.
When Y communicaon cable is installed on
COM1, it disables BT connecon. In order to
communicate via Bluetooth, COM1 cable must
be removed from COM1 port.
In order to communicate, all the parameters
from bandwidth to modulaon format need
to match up. It is advisable to check all the
parameters before starng any UHF base / rover
operaon.
There are 32 dierent frequncies can be tuned
/ assigned to radio channels in case of using
dierent frequencies for dierent purposes.
Consequently, selecng the same channel and
so frequency is crucial to communicate.
Symptom Possible Reason Soluon
6. Trouble Shoong