SATO CL4NX - Page 116

6 Installation of Options
114
CL4NX/CL6NX Service Manual
7 Slide to attach the media holder plate 0
back and tighten three screws
".
Refer to step 4 for the positions of three screws ".
8 Place the spring & and rewind core
unit
' through the rewind shaft ).
Rotate the rewind core unit ' such that the
groove on the inner core nested on the protruding
tab of the torque limiter.
Properly nested rewind core unit allows the
E-ring
+ to lock on the rewind shaft ).
9 Insert the oiles bearing * to the center
hole of the rewind core unit
'.
10 Using a pliers, attach the E-ring + to the
groove of the rewind shaft
).
10
11
Slide
15
Inner view of
rewind core
14
16
17
Torque limiter
18
Fully inserted
17
16
18