SATO CL4NX - Cutter Problem

3 Troubleshooting
33
CL4NX/CL6NX Service Manual
3.1.6 Cutter Problem
Category
Symptom
Cause Remedy
Maintenance
NO
Cutter
Is the
print mode set
correctly?
YES
No cutting
motion
NO
Is the
cutter cable
connected?
YES
Connect the
cutter cable
Replace the
cutter unit
Replace the
cutter PCB
NO
Is the
cutter blade
position
correct?
YES
Feed the media
and move the
cutter blade to
home position
NO
Is the
cutter blade
clean?
YES
Cannot cut
the media
Replace the
cutter unit
Replace the
cutter PCB
Is the
cutter blade
clean?
YES
Clean the
cutter blade
Clean the
cutter blade
Refer to 4.4.1 in
CL4NX/CL6NX
operator manual
Set the print
mode to
Cutter
NO