6 Installation of Options
121
CL4NX/CL6NX Service Manual
5 Cut three joints using a nipper to remove
the portion in the circle of the media
holder plate
0.
Make sure that there is no burr remains on the cut
surface.
6 Attach the gearbox # of the liner rewinder and tighten four screws %.
• First, route the motor cable & around the motor as shown. Do not overlap on the shaded area of the
motor.
• Attach the gearbox
# using four screws %. Make sure that the motor cable is not pinched.
• Then, tie the motor cable
& using a cable tie ' as shown. Do not overlap the motor cable & on the
shaded area.
• Lastly, insert the motor cable
& into the slot at the bottom of the printer center frame.
Joint
11
12
13
15
14
14
To Next Page
Loading...
