SATO CL4NX - Page 136

6 Installation of Options
134
CL4NX/CL6NX Service Manual
18 Connect the cutter cable *to the PCB
on the linerless cutter unit
.
19 Attach the linerless cutter unit to the
printer and tighten four screws
.
Note
Be careful not to pinch the cables.
20 Pull the tab to open the cutter-open
lever, attach the front cover
 of the
cutter and tighten two screws
$.
21 Close and lock the cutter-open lever.
21
17
20
Place both
cables
between the
brackets.
Arrange such that
the sensor cable
is in the inner side.
21
20
22
3
23
22
Open