SATO CL4NX - Page 153

6 Installation of Options
151
CL4NX/CL6NX Service Manual
6 Pass the antenna wire # of the
media guard (RFID)
% through the hole
of the frame as shown.
Pull out the antenna wire from the PCB side.
7 Place and press the
media guard (RFID)
% down onto the
engine frame.
8 Attach the media guard (RFID) % using
two screws
" removed in step 5.
9 Return the media sensor guide , to its
original position and tilt the
sensor guide lock
( up to the locked
position.
13
12
Press down
Check rib
insertion
10