SATO CL4NX - Page 93

5 Replacement
91
CL4NX/CL6NX Service Manual
Notes on installing the BF spring
1. Place the straight end of the BF spring onto the
left side of the RED dotted line as shown.
2. Turn the other end of the BF spring (L-angle)
counterclockwise, approximately 3 quarters
rotation, to the RED dotted line. Cross over the
straight end position and then hook to the
projection of the frame and BF stopper.
Striaght end of
the BF spring
L-angle end of
the BF spring
Striaght end of
the BF spring
L-angle end of
the BF spring