Page 9-4
Section 9. Optional Accessories
SATO CL608e/CL612e Service Manual
PN 9001079
Rev. B
Label Cutter Kit Installation
ROUTE CABLE CONNECTORS FROM
THE CUTTER THROUGH ACCESS
HOLE IN PRINT ENGINE ASSEMBLY
AND THROUGH THE HOLE IN THE
ALUMINUM SIDE PLATE
REMOVE (2)
SCREWS AND
DISCARD BRACKET
Figs. 9-5
Fig. 9-3
DETACH EXISTING CABLE FROM
THE CUTTER PCB AT “CUTP”
AND “CUTS”.
INSTALL NEW CABLE AT SAME
LOCATIONS
Fig. 9-4
CUTTER UNIT
To Next Page
Loading...
