SATO CT400 - Page 128

COMMAND
PARAMETER
HEX
VALUE
DESCRIPTION
j 00 Zero Slash disabled
01 Zero Slash enabled
k 00 Reserved
l 00 Paper Type, Labels
01 Paper Type, Fan-Fold
m 00 Autofeed disabled
01 Autofeed enabled
n 00 Pitch Fixed
01 Pitch Proportional
0 000 to C80 Vertical Label Size (0 to 3200 dots)
p 000 to 340 Horizontal Label Size (0 to 832 dots)
q 000 to 792
FFFF to FCE8
Vertical Offset (0 to 792 dots)
Vertical Offset (-1 to -792 dots)
r 000 to 792
FFFF to FCE8
Horizontal Offset (0 to 792 dots)
Horizontal Offset (-1 to -792 dots)
s 00 to 63 Pitch Offset (0 to 99 dots)
t 00 to 63
FF to 9D
Tear Off Offset (0 to 99 dots)
Tear Off Offset (-1 to -99 dots)
u 00 to 63
FF to 9D
Cut Offset (0 to 99 dots)
Cut Offset (-1 to -99 dots)
v 00 to 63
FF to 9D
DispenseOffset (0 to 99 dots)
Dispense Offset (-1 to -99 dots)
w 00 Reserved
x 00 to 40 Gap Size (0 to 64 dots)
y 00 Buzzer Enabled
01 Buzzer Disabled
Placement: Separate data stream sent to printer
Default: None
Command Function To set the printer default configuration into EEPROM
Input to Printer
<ESC>A
<ESC>PG
<ESC>Z
Printer Output There is no printer output as a result of this command.
Page 4-849001069A SATOCTSeriesPrinters