PRINT TEST LABELS
USER TEST PRINT
The User Test Label prints the current default setting of the printer. These settings
can be changed by sending new default settings with the <ESC>PG Printer Setting
command.
1. Press the FEED key while simultaneously turning the POWER switch ON.
2. When the printer beeps, release the FEED key.
3. To print a large (4" wide) test label, press the ON-LINE key.
To print a small (2" wide) test label, press the FEED key.
4. The printer will continuously print the USER TEST LABEL until the FEED key is
pressed. If the FEED key is pressed a second time, printing will resume.
5. To remove the printer from the Test Label mode, power the printer OFF.
Section 2. Installation and Configuration
Page 2-209001069A SATOCTSeriesPrinters
To Next Page
Loading...
