Job Name
Command Structure <ESC>WKnnn...n
nn..n = Job Name assigned, up to 16 ASCII characters
Example: <ESC>WKSATO
Placement: Immediately following the <ESC>A in the job data stream.
Default: None
Command Function This command is to identify a particular job using a descriptive name
Printer Input
<ESC>A
<ESC>WKSATO
. . . Job . . .
<ESC>Z
Printer Output There is no printer output as a result of this command. The
information is returned to the host upon receipt of a Bi-Com status
request.
Special Notes 1. Works only in Bi-Com mode. The Job Name must be stored before
Bi-Com status mode can be used.
2. If more than one Job Name is sent in a single job, i.e.
<ESC>A
<ESC>WKSATO
..........
<ESC>WKSATO AMERICA
.........
the last name transmitted will be used.
Section 4. Programming Reference
Page 4-509001069A SATOCTSeriesPrinters
To Next Page
Loading...
