HEX DUMP DIAGNOSTIC LABEL
The contents of the printer buffer can be examined using the Hex Dump mode. This
printout labels each line of the received data in the left hand column, the data in hex
format in the middle column followed by the same data in ASCII format in the
right-hand column.
1. Turn the printer OFF.
2. Place DSW7 on the configuration Switch in the ON position.
3. Turn the printer ON.
4. Transmit data to the printer.
5. The data received is printed on the label.
6. Place DSW7 in the OFF position.
7. Turn the printer OFF and then back ON to place it back in the normal print mode.
Section 2. Installation and Configuration
SATOCT SeriesPrinters9001069A Page2-19
To Next Page
Loading...
