Font Configuration (SOH + FG)
Upon Receipt of an SOH (hexadecimal 01) followed immediately by an FG
(hexadecimal 4647) causes the printer to return a 102 byte Font/Graphics Status
Word bounded by an STX-ETX pair that reports information on the stored font or
graphic.
Note: The printer must be in the Font/Graphic Download (See Section 2:
Configuration Switch) mode before a response will be received.
BYTE
NUMBER
VALUE DESCRIPTION
1-2 ASCII Font ID Number
3-4 00
H
01
H
Font
Graphic
5-36 ASCII Font Name
37-48 ASCII Font Style
49-52 ASCII Font Point Size
53-54 Binary Character Width in dots
54-60 Binary Character Height in dots
57-60 Binary Font Size
58-64 Binary Font Registration Number
65-68 Binary Font Data Top Address
69-72 Binary Total Size
73-74 Binary Vertical/Horizontal Writing Flag
75 Binary Character Pitch, Fixed/Variable
76 Binary Family Attribute
77 Binary Character Set
78 Binary Italic Attribute
79-80 Binary Weight Attribute
81-82 Binary Spread
83-84 Binary Assent in dots
85-86 Binary Registration Start Code
86-87 Binary Registration End Code
88-95 Binary Reserved
96-98 Binary Code
99-100 Binary Horizontal Valid Size
101-102 Binary Left Gap Size
Section 5. Interface Specifications
Page5-169001069A SATOCTSeriesPrinters
To Next Page
Loading...
