SATO CT400 - Page 74

Special Notes 1. Use the Print Position commands (V and H) to locate the new area
for the duplicate image.
2. Position of the new target area must not be inside the original
image.
3. If you use the Rotate command, V, H, X and Y axes will be
reversed.
4. If the reference area of the target image exceeds the print area, it
will not be printed.
5. The allowable ranges for these fields are as follows:
CT400 CT410
Horizontal
aaaa
cccc
0001
to
0832
0001
to
1248
Vertical
bbbb
dddd
0001
to
3200
0001
to
4800
Section 4. Programming Reference
Page 4-309001069A SATOCTSeriesPrinters