Special Notes 1. Auto-smoothing (when enabled) is only effective if the character
expansion rate is at least (3) times in each direction.
2. Characters may be enlarged through the use of the <ESC>L
Character Expansion command.
3. Character spacing may be altered through the use of the <ESC>A
Character Pitch command.
4. A font must be defined for each field to be printed. There is no
default font.
5. The proportionally spaced fonts XU, XS, XM, XL and XB can be
printed with fixed spacing using the <ESC>PS Proportional Space
command.
6. The WB and WL fonts are not available in the initial production CT
printers. Please contact your SATO representative and make
arrangements to have your printer upgraded if these two fonts are
not present.
Section 4. Programming Reference
SATOCT SeriesPrinters9001069A Page4-41
To Next Page
Loading...
