SATO GY412 - Safety Precautions; Pictographic Symbols and Warnings

SATO GY412
2
Configuring your SATO Printer for
eFORMz
Thank you for your investment in Minisoft eFORMz and the SATO GY412.
This guide contains the recommended settings and installation tips to get the
most out of your printer and eFORMz.
For more information on your SATO view the Operator Manual here:
https://www.satoamerica.com/uploads/les/datasheets/GY412%20Operator%20
Manual.pdf
Recommended Settings
To ensure that eFORMz and your SATO GY412 printer work together
eciently, complete the following procedures:
• Update the rmware
• Set the sensor type
• Set the printer type
Restarting Your Printer
When powering the SATO printer wait for the display screen to go dark, at
least ve seconds, before turning it back on again. Quickly cycling the printer
o and on again can cause damage to the unit.
Out of Bounds Errors
The SATO printer can exhibit odd behavior if the eFORMz project is
attempting to print data outside the printable area. Behavior includes
printing blanks between labels and printed Labels being retracted then fed
out again skipping an entire label.
IMPORTANT!