SATO GY412 - Installation and Handling Precautions; Site Location and Power Supply

SATO GY412
4
Set Sensor Type
The recommended sensor type is I-MARK.
1. Press the LINE button to set the printer to OFFLINE mode.
2. Press ENTER and use the arrow keys to select the wrench and hammer
icon for ADVANCED mode.
3. Press ENTER until you reach SENSOR TYPE screen. Change the setting to
I-MARK by using the arrow keys.
4. Press ENTER once more to save the setting.
5. Press the FUNCTION button to exit out of the menus.
6. Press the LINE button to set the printer back to ONLINE mode.
7. It is recommended that you power the printer OFF and ON again to
ensure the conguration is saved and loaded.