SATO GY412 - Introduction to the GY412 Printer

SATO GY412
8
Print Conguration Labels
Complete the following steps to print the printer conguration:
1. Turn OFF the printer. Wait until the screen goes dark.
2. Press and hold the FEED button down and turn the printer ON. This
will place the printer in TEST PRINT MODE. Use the arrow keys to select
CONFIGURATION.
3. Press ENTER to go to the TEST PRINT SIZE. Select the print size with the
arrow keys.
4. Press ENTER once to go to PITCH POSITION UPPER.
5. Press ENTER to begin printing the conguration labels. Make sure labels
have been loaded into the printer.
6. The printer will continue to print out conguration labels until you press
the ENTER key to stop the process.
7. Press the CANCEL or FUNCTION to go back to the TEST PRINT MODE
screen.
8. Turn the printer OFF then back ON again to set the printer to ONLINE
mode.