SATO GY412
7
Loading Labels
Prerequisite: Congure the SENSOR TYPE as explained in Set SENSOR TYPE
on Page 4.
1. Switch on power.
2. Position stack of fanfolded label media to the rear of the printer.
3. Insert the leading edge of the fanfold label media in the label feed
entrance at the top rear of the printer. The printer will automatically
feed it. Depending on the sensor type to be used, when you turn on
the power, the top of the label or I-MARK will be detected and then, the
printer will feed the label to the standby position.
To Next Page
Loading...
