SATO M84PRO - Flash Memory

Section 4: Accessories Installation
M84Pro Service Manual PN: 9001111A Page 4-7
12 Restore power and test cycle.
Figure 4-2c, Dispenser Installation
FLASH MEMORY INSTALLATION
1 Switch off the printer and disconnect the power supply cord.
2 Open/remove the top, right, and left housing covers.
3 Remove three screws (1, Figure 4-3) securing daughter board (2) to main circuit board (3).
4 Disconnect daughter board (2) from circuit board (3).
5 Insert flash card (4) into its reserved brackets on main circuit board (3).
NOTE: Figures 10-1, 10-2, and 10-3 in the Diagrams & Schematics section
provide guidance on housing cover, media, and ribbon installation.
NOTE: Figure 10-1 in the Diagrams & Schematics section provides guidance
on housing cover removal.
NOTE: The flash card will properly insert into the connector bracket in a
single orientation. Ensure that the contactor side is goes first then press
inward to index the notched areas.
I
N
T
E
R
F
A
C
E
M
A
I
N
C
I
R
C
U
I
T
B
O
A
R
D
D
A
U
G
H
T
E
R
B
O
A
R
D
P
O
W
E
R
B
O
A
R
D
B
O
A
R
D
P
A
N
E
L
B
O
A
R
D
L
C
D
B
E
L
T
C
O
N
F
I
G
U
R
A
T
I
O
N
6
7
5
3