SATO M84PRO - Printer Setup and Mode Selection

Section 5: Printer Configuration
M84Pro Service Manual PN 9001111A Page 5-3
PRINTER SET UP
Print Mode Selection (DSW2-1): Selects between direct thermal printing and thermal transfer
printing.
Sensor Type Selection (DSW2-2): Selects between the use of a transmissive label gap or a
reflective eye-mark sensor.
Head Check Selection (DSW2-3): When selected, the printer will check for head elements that
are electrically malfunctioning.
Hex Dump Selection (DSW2-4): Selects Hex Dump mode.
DSW2-1 SETTING
Off Therm Xfr
On Direct Therm
DSW2
ON
OFF
12345678
DSW2-2 SETTING
Off Gap
On Eye-Mark
DSW2
ON
OFF
12345678
DSW2-3 SETTING
Off Disabled
On Enabled
DSW2
ON
OFF
12345678
DSW2-4 SETTING
Off Disabled
On Enabled
DSW2
ON
OFF
12345678