SATO SA408 - 1 Introduction; Proprietary Statement; Product Improvements; FCC Compliance Statement

4
SA408 - User’s Manual
1. Introduction
Proprietary Statement
This manual contains proprietary information of SATO HOLDINGS CORPORATION.
It is intended solely for the information and use of parties operating and maintaining
the equipment described herein. Such proprietary information may not be used,
reproduced, or disclosed to any other parties for any other purpose without the
expressed written permission of SATO HOLDINGS CORPORATION.
Product Improvements
Continuous improvement of products is a policy of SATO HOLDINGS
CORPORATION. All specifications and signs are subject to change without notice.
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that the
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and the receiver.
 Connect the equipment into a different outlet on a different circuit.
 Consult the dealer or an experience Radio/TV technician for help.
This unit was tested with shielded cables on the peripheral devices. Shielded cables
must be used with the unit to insure compliance. The user is cautioned that any
changes or modifications not expressly approved by SATO HOLDINGS
CORPORATION could void the user’s authority to operate the equipment.
Liability Disclaimer
SATO HOLDINGS CORPORATION takes steps to assure that the company’s
published engineering specifications and manuals are correct; however, errors do
occur. SATO HOLDINGS CORPORATION reserves the right to correct any such
errors and disclaims any resulting liability. In no event shall SATO HOLDINGS
CORPORATION or anyone else involved in the creation, production, or delivery of
the accompanying product (including hardware and software) be liable for any