8 Specifications
This chapter provides specifications of your printer. Specifications are subject to
change without notice.
8.1
Printer
Model WS408DT WS412DT
Print method Direct Thermal
Resolution 203 dpi (8 dots/mm) 300 dpi (12 dots/mm)
Media Alignment Centered
Operation Mode
Standard: Continuous mode, Tear-off mode
Optional: Cutter mode, Dispenser mode
Sensor
Media Sensor: Gap Sensor (Transmissive, Fixed)
I-Mark Sensor (Reflective, Movable)
Head Open Switch
Print Speed
2, 3, 4, 5, 6 inches/sec
(50.8, 76.2, 101.6, 127, 152.4
mm/sec)
2 &3 ips for peel off mode
2, 3, 4 inches/sec
(50.8, 76.2, 101.6 mm/sec)
2 &3 ips for peel off mode
Print Darkness
Darkness level – SBPL: 1~5
Default – SBPL: 3
Max Printable
Area
Length 999 mm x Width 104
mm
Length 999 mm x Width
104 mm
Non-Printable
Area
Pitch Direction - Top: 1.5 mm, Bottom: 1.5 mm (excluding liner)
Width Direction - Left: 1.5 mm, Right: 1.5 mm (excluding liner)
Print Ratio
Average print ratio within 15 % or less (whole print layout
area)
Full width with 1 mm pitch is required
Interface
STD Model: USB (Type A and Type B), Ethernet, RS232C
LAN Model: USB (Type A and Type B), Ethernet
Optional Interface Wireless LAN, Bluetooth
Accessories Dispenser, Full Cutter, External Unwinder
CPU 32bit RISC
To Next Page
Loading...
