WS4-DT-r01-30-12-16TM
3.2
Reset Your Printer
By resetting your printer, you can return your printer to the state it was in when
you receive it. This can help you solve some problems caused by settings changed
during the printing.
Do the following to reset your printer:
1. Turn off your printer.
2. Press and hold the FEED button, and turn on your printer.
3. Both status lights glow solid orange for a few seconds. Next, they turn to green
shortly and then turn to other colors. When both lights turn to red, release the
FEED button immediately.
4. Press and hold the FEED button for 3 seconds and release it. Both status lights
blink red three times, and turn to solid orange for a few seconds. After your
printer is reset, LED 2 goes out while LED 1 turns to solid green.
Important In step 4, if you do not hold the FEED button long enough, LED 2
will blink orange three times while LED 1 goes out. It means your printer is not
reset.
To Next Page
Loading...
