WS4-DT-r01-30-12-16TM
3.3.2 Dump Mode
Your printer enters Dump mode after running a self-test. In this mode, characters
are printed in hexadecimal codes, allowing users and engineers to debug the
system.
To return to the online mode:
■
Turn off your printer and turn it on again.
■
In SATO WS4 Printer Utility, in the Navigation pane, click Tool. In the
Properties pane, click Reboot Printer and click Send.
This is applicable for SZPL, SDPL and SEPL.
To Next Page
Loading...
