WS4-DT-r01-30-12-16TM
2.5
External Unwinder
An external unwinder can hold up to 8-inch outer diameter media roll. It allows
you to print labels without frequently replacing media rolls.
To install an external Unwinder:
1. Slide the Unwinder Holders into the Holder Slots, until the holders snap into
the place.
2. Thread the power cord and the connection cable into the bottom slot of
Unwinder Base, until they reach out of the front slot.
3. Insert the Holder Shaft into your media roll.
4. Do one of the following to assemble the Holder Shaft and the Roll Stops:
To Next Page
Loading...
