WS4-DT-r01-30-12-16TM
3. Reinstall the middle frame.
4. Plug the Bluetooth cable to J15, which is the black port located to the
lower-right of the main board.
Step 3. Reinstall the base and the tear bar
This part describes how to reinstall the parts you took off.
1. Plug all other cables back into the main board.
2. Reinstall the base and the secure it with four screws.
3. Turn over your printer.
4. Reinstall the tear bar and secure it with two screws.
5. Close the top cover.
To Next Page
Loading...
