WS4-DT-r01-30-12-16TM
3.3
Self-Test and Dump Mode
Your printer can run a self-test to print a configuration label, which helps you
understand the current settings of your printer.
3.3.1 Self-Test
1. Turn off your printer.
2. Press and hold the FEED button and turn on your printer.
3. Both status lights glow solid orange for a few seconds. Next, they turn to green
shortly, and then turn to other colors. When LED 1 turns to orange and LED 2
turns to green, release the FEED button.
4. Press the FEED button to print a configuration label.
Your printer has five (5) emulation languages: SZPL. The figure below shows its
configuration label.
To Next Page
Loading...
