WS4-DT-r01-30-12-16TM
3 System Mode
The system mode consists of status light color combinations. It contains a list of
commands for you to select and run.
To enter the system mode and run the command, do the following:
1. Turn off your printer.
2. Press and hold the FEED button and turn on your printer.
3. Both status lights glow solid orange for a few seconds. Next, they turn to green
shortly and then turn to other colors.
4. When status lights show the color combination you need, release the FEED
button immediately.
5. Press the FEED button to run the command.
The following table is the command list of the system mode.
LED 1 LED 2 Command
Green Red Transmissive Sensor Calibration
Green Orange Reflective Sensor Calibration
Red Red Reset Your Printer
Red Orange Reserved
Orange Red Reserved
Orange Green Self-Test and Dump Mode
To Next Page
Loading...
