WS4-DT-r01-30-12-16TM
●
If the inside diameter of the media roll is 1-inch, make sure the Core Holders
are facing inward, and then insert the Roll Stops into each end of the Holder
Shaft.
●
If the inside diameter of the media roll is 3-inch, make sure the Core Holders
are facing outward, and then insert the Roll Stops into both ends of the Holder
Shaft.
5. Place the Holder Shaft on the Unwinder Holders.
6. Place your printer on the Unwinder Base. Fit your printer’s rear rubber feet
into the Rubber Foot Slots.
7. Attach the power cord and the connection cable to your printer.
8. Pull out the media and thread it into the rear slot of your printer.
To Next Page
Loading...
