WS4-DT-r01-30-12-16TM
ā ā
9. Reinstall the middle frame.
10. Plug the Wireless LAN cable 1 (white connector) to J13, which is the white port
located to the lower-right of the main board.
11. Plug the Wireless LAN cable 2 (black connector) to J15, which is the black port
located to the lower-right of the main board.
Step 3. Reinstall the base and the tear bar
This part describes how to reinstall the parts you took off.
1. Plug all other cables back into the main board.
2. Reinstall the base and the secure it with four screws.
3. Turn over your printer.
4. Reinstall the tear bar and secure it with two screws.
5. Close the top cover.
To Next Page
Loading...
