Property Name Description
Inch
Change the unit of Position Adjustment to inch.
dots
Change the unit of Position Adjustment to dots.
Horizontal Offset Move the print position horizontally. The positive number
is left, and the negative number is right.
Vertical Offset Move the print position vertically. The positive number is
forward, and the negative number is backward.
Continuous Offset Adjust the continuous offset at which the continues label is
cut.
Tear Off Offset Adjust the rest position of the media after a label is
printed, which changes the position at which the label is
torn or cut.
Cutter/Dispenser
Offset
Adjust the cutter/dispenser offset position at which the
label is peel or cut.
Status This is communication protocol for SBPL. Status 3 is Enq
response and Status 4 is for the communication via driver.
STX Code When you use non-standard code, you can set the code in
this section.
ETX Code When you use non-standard code, you can set the code in
this section.
ESC Code When you use non-standard code, you can set the code in
this section.
ENQ Code When you use non-standard code, you can set the code in
this section.
CAN Code When you use non-standard code, you can set the code in
this section.
NULL Code When you use non-standard code, you can set the code in
this section.
Offline Code When you use non-standard code, you can set the code in
this section.
To Next Page
Loading...
