Property Name Description
characters excluding double quotation marks
(“). Pre-shared key authentication is for home
or small offices.
Module Restore Default It resets all values in the Wireless LAN module.
Network Type
It determines how you connect your printer to
a network.
Infrastructure
If you connect through an
access point, select this.
Ad hoc if you connect through a device
which has connected to a network, select this.
In Ad hoc mode, you can only use Open
authentication.
Region The country or region.
Channel The Wireless LAN channel. You need to use the
same channel as other devices for
communication. The available channel varies
according to your region.
SSID The service set identifier. It is the name of a
wireless network.
Port Number The wireless LAN port number of your printer.
Channel (Current) The current Wireless LAN channel.
SSID (Current) The current service set identifier.
DHCP
Auto
It tries to get an IP address from a
DHCP server first. If failed, it uses the specified
one.
Enable
It keeps trying to get an IP address
from a DHCP server until it succeeds.
Disable
It uses the specified IP address.
Host Name It is the name of a DHCP client. The host name
allows up to 32 alphanumeric characters. You
can leave it blank or type a name you want. By
default, there is no host name.
EAP Method
It is available for 802.1X, WPA-Enterprise and
WPA2-Enterprise authentication.
EAP-LEAP
LEAP stands for Lightweight
Extensible Authentication Protocol. It changes
To Next Page
Loading...
