SATO WS408DT - 2.2 Turn on;off your printer

2 Get started Load media
WS4-DT/TT-r01-12.1.17-OM-RS
11
2.2 Turn on/off your printer
When your printer is connected to a host (a computer), it is good to turn on the
printer before turning on the host, and turn off the host before turning off the
printer.
2.2.1 Turn on your printer
1. To turn on your printer, turn on
the Power Switch as below. The
“I” is the ON position.
2. Both status lights glow solid
orange for a few seconds, and
then LED 2 goes out, while LED 1
turns to solid green.
2.2.2 Turn off your printer
1. Make sure LED 2 is off and LED 1 is
solid green before turning off the
printer.
2. To turn off your printer, turn off the
Power Switch as below. The “O” is
the OFF position.
Caution Do not turn off your printer during data transmission.