SATO WS408DT - 11 Specifications; 11.1 Printer

11 Specifications Printer
WS4-DT/TT-r01-12.1.17-OM-RS
72
11 Specifications
11.1 Printer
Model
WS4DT and WS4TT
Print method
Direct Thermal and Thermal Transfer
Resolution
203 dpi (8 dots/mm) 300 dpi (12 dots/mm)
Media
Alignment
Centre Alignment
Operation Mode
Standard: Continuous, Tear-off
Sensors
Media Sensor
DT: Gap Sensor (Transmissive, fixed)
TT: Gap sensor(Transmissive, fixed) Offset:
6.27mm - Factory Default Sensor
I-Mark Sensor (Reflective, Movable)
Head Open Switch
Ribbon Sensor
Print Speed
WS408: 2, 3, 4, 5, 6 ins/sec (50.8, 76.2, 101.6, 127, 152.4mm/s)
WS412: 2, 3, 4 ins/sec (50.8, 76.2, 101.6mm/s)
2 &3 ips for dispenser mode
Do not set Print Speed to 4 ips or higher speed, when the
peeler module is installed and the peeler cover is open.
Print Darkness
Darkness level –SBPL: 1 ~ 5
Default – DT: SBPL 3 TT: SBPL 3
Max Printable
Area
Length 999 mm x Width 104 mm
Non-Printable
Area
Pitch Direction - Top: 1.5 mm, Bottom: 1.5 mm (excluding liner)
Width Direction - Left: 1.5 mm, Right: 1.5 mm (excluding liner)
Interface
STANDARD Model: USB (Type A and Type B), Ethernet, RS232C
LAN Model: USB (Type A and Type B), Ethernet
Optional
Interface
Bluetooth, Wireless LAN
On-Board
Memory
Standard Memory (Flash ROM): 16 MB
User Memory: 2 MB