2 Get started Load media
WS4-DT/TT-r01-12.1.17-OM-RS
13
1. Press the holder lock on the Media Roll Holders to slide them outward, and
place the media roll between the holders. Make sure the print side is up, and
the media roll is clamped tightly by the holders.
Note The default core holder is set for 1-inch inside diameter (ID). To
install a 1.5-inch ID media roll, use your hand or a coin to loosen two
thumbscrews on both holders, flip the core holders horizontally and secure
them back.
To Next Page
Loading...
