2 Get started Load media
WS4-DT/TT-r01-12.1.17-OM-RS
23
To load the take-up roll, align the notches on the left side and press the roll to the
take-up hub, and then press the right side of the roll to the hole.
5. Pull the ribbon from the supply roll and tape it onto the top of the take-up roll.
6. Close the printer module and press down firmly at its both sides, until you hear a
click.
7. Check that the ink side of the ribbon is facing outwards so that the ribbon ink will
be in contact with the labels. If necessary, reverse the ribbon to achieve this.
To Next Page
Loading...
