12 Safety precautions
WS4-DT/TT-r01-12.1.17-OM-RS
82
Do not set on an unstable area
Do not set on an unstable area, such as a wobbly table or
slanted area or an area subject to strong vibration. If the
printer falls off or topples over, it could injure someone.
Do not place containers full of water or other liquid on the printer
Do not place flower vases, cups, or other containers
holding liquids, such as water or chemicals, or small metal
objects near the printer. If they are spilled and get inside
the printer, immediately turn off the power switch, unplug
the power cord from the outlet, and contact your SATO
reseller or technical support center. Using the printer in
this condition could cause a fire or electric shock.
Do not put objects inside the printer
Do not insert or drop in metal or burnable objects inside
the printer’s openings (cable outlets, etc.). If foreign
objects do get inside the printer, immediately turn off the
power switch, unplug the power cord from the outlet, and
contact your SATO reseller or technical support center.
Using the printer in this condition could cause a fire or
electric shock.
Do not use other than the specified voltage
Do not use other than the specified voltage. Doing so
could result in fire or electric shock.
Always ground the connections
Always connect the printer’s ground wire to a ground. Not
grounding the ground wire could result in electric shock.
Handling of the power cord
Do not damage, break, or modify the power cord. Also, do
not place heavy objects on the power cord, heat it, or pull
it because doing so could damage the power cord and
cause a fire or electric shock.
If the power cord becomes damaged (core is exposed,
wires broken, etc.), contact your SATO reseller or technical
support center. Using the power cord in this condition
could cause a fire or electric shock.
To Next Page
Loading...
