WS4-TT-r01-30-12-16TM
6. Loosen and remove the two screws on each side of the Media Roll Holders.
7. Remove the middle frame along with the top cover.
Step 2. Connect and secure the cutter to your printer
This part describes how to thread the cutter cable and wire, connect them to the
main board and secure the cutter and reinstall the part you took off.
1. Thread the cutter cable through the square hole to the right of the print
module.
2. Plug the cutter connector to the J8 on the main board. J8 is a white port
To Next Page
Loading...
