WS4-TT-r01-30-12-16TM
located to the rightmost of the main board.
3. Put the dispenser on the print module.
4. Reinstall the middle frame along with the top cover. Make sure the dispenser
wire is inside the middle frame.
5. Secure the middle frame to the printer.
6. Open the dispenser and insert the bracket under the platen roller to position
the dispenser in front of the printer.
7. Locate the two screw holes under each side of the bracket. They are the same
screw holes used by the tear bar. Secure the dispenser with two screws.
To Next Page
Loading...
