Property Name Description
that generates the second half of a unicast IPv6
address (last 64 bits) from a MAC address. You can also
specify the second half of the address by entering the
interface ID.
ANY
It uses a 128-bit any cast address that you
specify. The printer needs to remember that the
current address is an any cast address, since its format
is the same as a unicast address.
IP Address (IPv6) The static IPv6 address of your printer.
Interface ID Short for interface identifier. It is used to identify the
network interface of a host. You can specify the
interface ID here.
IP Address
(Current IPv6)
The current IPv6 address of your printer.
Link-Local Address It is used for communications on a local network. The
address always starts with FE80.
Set up IPv6 connection
Before you set up IPv6, make sure you have IPv6 connectivity.
1. Do one of the following to configure your IPv6 settings:
•
If you have a static IPv6 address, in the Mode list, click MANUAL; in the IP
Address box, enter your IPv6 address and click Send.
•
If you don’t have a static IPv6 address, in the Mode list, click DHCPv6; in the
Address Type list, click Normal and click Send.
To Next Page
Loading...
