8. Click Send to run the command on your printer.
Note
If you send a command file and your printer doesn’t respond, it is possible
that the emulation language is not set correctly. Click Sync to get the current
setting of Printer Emulation.
Tool
Tool is used to send specific commands to your printer. It has the Single Command
tab, which provides three commands.
■
Reboot Printer Restart your printer.
■
Reset to Default Setting Reload factory settings.
■
Test Print Run a self-test to print a configuration label.
■
Change Emulation Change the emulation language for your printer.
■
Media Calibration Change the media sensor for your printer.
■
Ribbon Calibration It calibrates the ribbon so that your print start position
will be more accurate.
•
RESET
Turn off Ribbon Calibration.
To Next Page
Loading...
