EasyManuals Logo

Savant HST-SIPA1SM User Manual

Savant HST-SIPA1SM
25 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
009-1839-04 | Savant IP Audio Products with Integrated Host Deployment Guide 45 Perseverance Way, Hyannis, MA 02601
200207 | © 2020 Savant Systems, LLC
23 of 25
Savant.com | 508.683.2500
Appendix A: Network Requirements
Savant requires the use of business class/commercial grade network equipment throughout the network to ensure the reliability of communication between
devices. These higher quality components also allow for more accurate troubleshooting when needed.
Device Network Connections
Connect all Savant devices to the same local area network (LAN) or subnet as the Host. Savant recommends not implementing any type of trac management,
packet shaping, band steering, QoS or similar features within the network topology for Savant devices, as this may interfere with performance.
AVB Requirements
Savant requires the use of an AVB/TSN compliant switch meeting IEEE standard 802.1BA+2011 for all IP Audio components utilizing AVB communication.
Managing IP Addresses
To ensure that the IP Address will not change due to a power outage, a static IP Address or DHCP reservation should be configured. Savant recommends using
DHCP reservation within the router. By using this method, IP Addresses for all devices can be managed from a single UI avoiding the need to access devices
individually.
Setting a Static IP Address
Setting a Static IP Address can be done in the Web UI on the Network Tab.
Setting DHCP Reservation
Setting DHCP reservation varies from router to router. Refer to the documentation for the router to configure DHCP reservation.
Network Changes
Savant recommends performing one of the following steps to refresh the IP connection after connecting to a new network, changing routers, or if the IP Address
range is changed in the current router. This will reset any IP connection and ensure that the Host is communicating with the network correctly.
Cycle Power
Disconnect the IP Audio device from the power source.
Wait 15 seconds and then reconnect.
Hot Plug the Ethernet (LAN) Connection
Disconnect the Ethernet (LAN) connection from the device.
Wait 15 seconds and then reconnect.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Savant HST-SIPA1SM and is the answer not in the manual?

Savant HST-SIPA1SM Specifications

General IconGeneral
BrandSavant
ModelHST-SIPA1SM
CategoryStereo System
LanguageEnglish