009-1839-04 | Savant IP Audio Products with Integrated Host Deployment Guide 45 Perseverance Way, Hyannis, MA 02601
200207 | © 2020 Savant Systems, LLC
6 of 25
Savant.com | 508.683.2500
3.3. Network Connection
Wired Connection
Savant IP Audio devices use a standard RJ-45 port complying with IEEE 802.3 Ethernet standards. This port also supports Audio Video Bridging
(AVB) or Time Sensitive Networking (TSN) over Ethernet (AVB/TSN, IEEE 802.1). Up to 45 IP Audio devices can be connected using AVB/TSN
compliant switching. For more information, see Appendix: Network Requirements.
Wireless Connection (HST-STUDIO55WS-SUR only)
The Smart Audio WiSA Soundbar contains a Wireless radio. Wireless connectivity is only available when operating in Host mode. Provisioning
can be done with the Savant SmartConnect App. For more information see the SmartConnect Software Reference Guide on the Savant Customer
Community.
3.4. Audio Connections
HST-SIPA1SM
Speaker Output
– Single zone speaker output. Uses included 4-pin speaker connector.
– Supports 8 ohm or 4 ohm speakers.
Analog Audio Input/Outputs
– 2-channel analog stereo connection (RCA)
Digital Audio Input
– Digital optical audio inputs (TOSLINK). Supports up to 192kHz/24-bit digital audio in; PCM stereo format only.
HST-STUDIOxx-2CH
Digital Audio Input
– Digital optical audio inputs (TOSLINK). Supports up to 192kHz/24-bit digital audio in; PCM stereo format only.
HST-STUDIO55WS-SUR
Digital Audio Input
– The Optical Input (TOSLink) support up to 192kHz/24-bit digital audio and up to 5.1 encoded audio.
Sub Out
– Wired sub-woofer connection. 3.5 mm analog audio connection, Direct line level, 2.1 V
RMS
max.
– This output is always active, there is no connection representation needed in the blueprint configuration.
To Next Page
Loading...
Need help?
General