36
BA 68
Schaeffler Technologies
Schaeffler OPTIME
Install sensor
with mounting plate
The mounting plate can be used to fix the sensor to a machine
with no thread,
Figure 20
, page 35. This requires a mounting plate,
suitable adhesive and a surface with a diameter of 32 mm.
Incorrect handling of the adhesive may cause injury. Follow the
adhesive instructions and the safety data sheet. Direct skin contact
with the adhesive can lead to injuries. Use suitable gloves.
There is a risk of damage if the adhesive is used incorrectly.
Select a suitable lubricant and observe the adhesive instructions.
The sensor fixing cannot be removed by non-destructive means
following installation.
Clean the machine surface.
Stick the mounting plate to the machine.
There is a risk of damage if the adhesive is used incorrectly.
Observe the curing times specified in the adhesive instructions.
Insert the threaded bolt into the screw-in thread of the mounting
plate.
Tighten the threaded bolt with a maximum torque of 5 Nm.
There is a risk of damage if the specified tightening torque is not
adhered to. Too low a torque can lead to a weak connection between
sensor and machine, while too high a torque can damage the sensor
and the threaded bolt.
Configure sensor
The sensor receives the network parameters automatically via the
OPTIME app. For configuration purposes, the minimum information
required is the machine type (for example: motor, pumps, fans).
All other data on the machine (such as the speed, power, bearing
types) are optional and primarily improve the result of the analysis.
These data can also be configured retrospectively via the
OPTIME app or in the Schaeffler IoT Hub.
For further information on the sensor in the OPTIME app,
see page 57.
To Next Page
Loading...
