56
BA 68
Schaeffler Technologies
Schaeffler OPTIME
Edit sensor
with
[
Installation
]
button
The [
Installation
] button opens the buttons [
Replace sensor
],
[
Trigger learning mode
] and [
Deactivate sensor
].
Use the [
Replace sensor
] button to replace a defective sensor or
a sensor with a dead battery at the same measuring point.
Use the [
Trigger learning mode
] button to put the sensor back into
learning mode. Use the [
Deactivate sensor
] button to switch off
the sensor.
Edit sensor metadata
with
[
Metadata
]
button
The [
Metadata
] button opens the [
Edit asset
] button. This is where
you can edit the sensor metadata and enter name, position on
machine and sensor type. These data are used to define the sensor
threshold values and improve the results of the analysis.
Use
[
Data
]
button to request
fresh KPIs and raw data for sensor
KPIs and raw data can be requested for the sensor.
The [
Data
] button opens the two buttons [
Request fresh KPI values
]
and [
Request fresh raw data
], which initiates a new measurement.
To Next Page
Loading...
