Adjusting outlet height
Adjust the outlets to the correct height before dispensing any beverages!
If a beverage has already been dispensed, the outlet may be warm!
There is a risk of squeezing ngers when moving the outlet!
► Hold the front of the outlet and move it to the desired position (see picture).
Adjustable tray height:
65 - 185 mm
Beverage output
All beverages dispensed from the machine are hot!
Do not reach under the outlet while a beverage is being dispensed!
Preparing coffee beverages
► Place a cup under the outlet.
► Move the outlet to the correct position.
► Press desired beverage button (LED next to the pressed button blinks green).
► After the beverage has been dispensed (LED stops blinking) remove the cup.
If programmed, the machine has two possible product layers for each button. To enter the
second product level press the SHIFT button before the product selection.
Preparing milk beverages
If programmed, milk beverages can also be dispensed using the beverage buttons.
Available beverages:
• Cappuccino
• Latte Macchiato
• Latte
• Hot milk, cold milk and milk foam
Connecting milk bag (option „Milk Smart“)
Comply with all hygiene regulations according to HACCP (see „Hygiene"). As an option, the
Schaerer Coffee Art Milk Smart can be assembled with an refrigerator besides the machine.
No more than 40 mm should be between the package of milk and the outlet. The milk tubes must
touch the bottom of the container! Milk that has already been warmed or that has exceeded its
expiry date will not produce milk foam!
► Place fresh and precooled milk (3 – 5°C) next to the machine.
► Insert both tubes (white = milk foam / blue = hot milk) with the nozzles downwards into the milk
bag.
To Next Page
Loading...
Need help?
General
