M. Schaerer Ltd. Cleaning instructions 05.2008 V05
Gewerbestrasse 15 QRCSCA_d_EN
3302 Moosseedorf
Switzerland
info@schaerer.com www.schaerer.com Order number: 021611
Daily cleaning
Schaerer Coffee Art
97 8
► Remove and wash drip grid under warm,
running water.
► Clean trip tray with a damp paper tis-
sue.
► Place drip grid back.
► Clean external surfaces with a damp
paper tissue.
Do not use any abrasives!
Follow hygiene regulations according to HACCP!
Extract from HACCP:
► Never re ll milk container. Always throw leftovers away.
► Always clean the milk container before lling it with fresh milk.
► Fill up with fresh milk, chilled to 3 °C - 5 °C, just before restarting the machine.
► Use pasteurized or ultra hightemperature treated (UHT) milk! Do not use raw milk! The milk must be homogonised!
► If equipped, the refrigerator / cooling unit (optional) must be cleaned at least once a week!
► Remove the cleaning container.
► Release the foamer head from the hold-
er (press the button).
► Pull off the tube from the foamer head.
► Dismantle the foamer head and wash it
under warm, running water.
► Remove residues with a brush.
► Carry out steps
1
to
9
with the weekly
cleaning agent (Weekpure).
Weekly cleaning:
10
Dosierung:
Weekpure: 100 ml
Wasser: 1000 ml
1
2
Refer to the safety instructions and to the chapter "Cleaning" inside the user manual!
Never reach into the machine or under the beverage outlets during the automatic cleaning!
The following cleaning possibilities are available:
1. Automatic rinsing = Self starting (programmed)
2. Hot rinsing = Press the
button once (rinse duration: ± 15 seconds)
3. Milk tube rinsing = Press the
button twice (rinse duration: ± 10 seconds)
4. Complete cleaning = Press the
button for 4 seconds (procedure described as follows):
1
2 3
4 5 6
► Press the button (± 4 seconds).
► Pull out the grounds container (within 5
sec.) and clean it.
► Clean the brew area with the brush.
► Place back the grounds container.
Wait until the display shows:
► Insert the cleaning tablet.
► Press the
button.
► Fill the cleaning container with water
and cleaning agent.
► Place the tubes in the container.
► Press the
button.
Wait until the display shows:
Wait until the display shows:
► Rinse the cleaning container and ll it
with 600 ml of cold water.
► Place the tubes in the container.
► Press the button.
Wait until the display shows:
Display
cleaning program
remove container
Display
cleaning program
insert tablet
Display
cleaning program
cleaning agent
Display
cleaning program
rinsing water
Display
Select product
12:00 01.05.2008
Machines without milk system:
► Continue with step
7
.
Machines with milk system:
► Continue with step
3
.
Dosage:
Daypure: 100 ml
Water: 1000 ml
Coffee system cleaning is run-
ning! (duration: ± 5 min.)
Milk system cleaning is running!
(duration: ± 1.5 min.)
Milk system rinsing is running!
(duration: ± 1.5 min.)
To Next Page
Loading...
