Programming www.schaerer.com
Display/ Display text Parameter description Setting
range
Notes
Eco Mode Reduced energy consumption during lighter use.
10 min (standard setting) after the last beverage
was dispensed, the machine switches to the
"Eco Mode". The control temperature is de-
creased. The heat-up time for the next beverage
to be dispensed is ca. . 15 sec.
Option 1: Inactive parameter
This parameter should be disabled if the ma-
chine constantly needs to be ready for use for
the following requirements:
• Dispensing coffee, milk, milk foam or hot wa-
ter with no wait time.
• The machine is working at full capacity
throughout the entire day.
• Mainly beverages with milk are dispensed.
Option 2: Active parameter
The parameter should be enabled if the machine
can also be used for the following reduced re-
quirements:
• If after a 10 min break in beverage dispens-
ing a wait time of ca. 15 sec does not present
a problem.
• If coffee beverages without milk account for
the main output at certain times of the day.
inactive
active
The standard setting is [in-
active].
Display backlighting is
switched off in the "Eco
Mode".
The button rings for pro-
duct selection remain illu-
minated.
"Eco Mode" is not support-
ed when a payment sys-
tem (MDB) is used.
Switching off The machine switches to Standby mode after a
period of inactivity based on the switching off
time has expired.
never, 30, 60,
90, 120, 150,
180 min
The standard setting is
[never].
Eco start time Starts the "Eco Mode" after a period of inactivity
based on the set "Eco start time".
► Set the value, e.g. 10 min, by pressing
and .
If no other beverage is dispensed after
10 min, the "Eco Mode" is activated.
001 min –
120 min
The standard setting is
[010].
SB reduction Setting for modifying the reduction of the steam
boiler temperature (SB).
► Set the value, e.g. [007], by pressing and
.
► Confirm by touching .
When the machine runs in Eco Mode, the
boiler temperature is decreased from
96°C to 89°C.
000°C –
080°C
The standard setting is
[007].
HW boiler reduction Setting for modifying the reduction of the hot wa-
ter (HW) boiler temperature during "Eco Mode"
operation.
► Set the value, e.g. [009], by pressing and
.
► Confirm by touching .
When the machine runs in Eco Mode, the
boiler temperature is decreased from
96°C to 87°C.
000°C –
080°C
The standard setting is
[009].
BA SCV_EN
V06 | 11.2015
81
To Next Page
Loading...
Need help?
General
