Scheppach WTS2000 - Introduction; Product Description (Fig. 1); Scope of Delivery

www.scheppach.com
GB
|
23
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such products must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Product description (g. 1)
1. Table
2. Protective cover
2a. Clamping screw Protective cover
3. Riving knife
4. Sliding table
5. Handle
6. Parallel stop
6a. Clamping handle Parallel stop
7. Angular stop
7a. Clamp handle Angle stop
7b. Guide rail Angle stop
7c. Clamping screws
7d. Locking screw
8. Transport protection
8a. Marking transport lock
9. O󰀨 switch
10. On switch
10a. Overload switch
11. Cover diamond cutting disc
12. Motor shaft
13. Internal ange
14. External ange
15. Fixing nut
16. Plug
17. Level indicator
18. Cable holder
19. Foot
3. Scope of delivery
• Operating manual
• Open-ended spanner, size 13/15 (A)
• Open-ended spanner, size 6/8 (B)
• Diamond cutting wheel (C)
• Protective cover (2)
• Splitting wedge (3)
• Parallel stop (6)
• Angle stop (7)
• Guide rail Angle stop (7b)
• Clamping screws (7c) (2x)
1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new product brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability
for damage to the product or caused by the product
arising from:
• Improper handling
• Non-compliance with the operating manual
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Application other than specied
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100,
DIN 57113 / VDE0113 not being observed
Note:
Read through the complete text in the operating manu-
al before installing and commissioning the device.
This operating manual should help you to familiarise
yourself with your product and to use it for its intended
purpose.
The operating manual includes important instruc-
tions for the safe, proper and economic operation of
the product, for avoiding danger, for minimising repair
costs and downtimes and for increasing the reliability
and extending the service life of the product.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the product in your country.
Keep the operating manual package with the power
tool at all times and store it in a plastic cover to pro-
tect it from dirt and moisture. They must be read and
carefully observed by all operating personnel before
starting the work.
The product may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards.
The required minimum age must be observed.